11. AWA FUNCTION
11-1. AWA Audible Weighing Assist
The AWA (Audible Weighing Assist) function will assist you to count a certain amount of pieces by listening to the buzzer sound. The buzzer sound changes its interval as the pieces getting close to, and stops at the target count.
There are three modes of operation. These can be selected by the 
key.
ƉOff mode: AWA function disabled.
ƉTarget mode: To set the number of pieces that you will count.
ƉInterval mode: To set the number of pieces as an interval count. For example, when 20 pieces is set as an interval count, the target count will be 20, 40, 60, … pieces.
The buzzer starts to beep at the “target count – 9” pieces. As you add pieces and the count is getting close to the target, the buzzer changes its interval of beeps, shorter and shorter. Finally it stops at the target count.
The buzzer will beep again for “target count + 1, 2, 3 or 4” pieces.
The minimum number of pieces to set is 10.
The number of pieces is set to less than 50 in the interval mode, the buzzer will start to beep at the “target count – 5” pieces.
If the number of pieces is not more than 9, the buzzer does not beep in either mode.
You cannot set the minus target or interval count. But the AWA function works for negative pieces, too.
The AWA function should be disabled when the comparator buzzer is used.
11-2. To Enable/Disable AWA Function
Press the 
key, then the display will show one of the three modes operation to set. The display moves among these setting modes cyclically by pressing the 
key to select one of them.
Press the RESET key in the setting modes, the scale returns to normal without changing the AWA function setting and the unit weight you are using.
Off Mode Setting
1.The count display shows “off” blinking.
2.When you do not use the AWA function, press the ENTER key. The display returns to normal with the AWA function deactivated.
Or, move to the other mode setting by
pressing the 
key.
COUNT
888.off02
WEIGHT | UNIT WEIGHT |
0000.
39
