A&D HC-15Ki, HC-3Ki, HC-30Ki, HC-6Ki Function Parameters, To Change or View F-Function Settings

9. F-FUNCTION PARAMETERS

9-1. To Change or View F-Function Settings

‰Start with the scale switched off.

1. Press and hold the			ZERO	key, then press	ZERO
the	ON/OFF	key.

+

ON

OFF

The count display will show “f-00” with “00” blinking. Then release the both keys.

2.Press the 0 Æ 9 keys to display the number of the F-Function section.

‰For example: the 5 key to enter into the F-Function F-05-X Comparator section.

8f-00810

8f-05810

3. Press the ENTER key.

The count display will show the	ENTER
F-Function and its present setting will
blink.

4.You may now either change the setting (Step

5)or move to the next F-Function (Step 6).

8f-05-01

0

5.Use the setting.

0

Æ

9

keys to change the 8f-05-01

The C key clears the input setting if you press the wrong key and want to re-enter.

1

If you make a mistake and want to escape without saving any changes made after the last time the ENTER key was pressed – press the ON/OFF key to exit.

After the ENTER key is pressed, the data is entered.

6. Press the ENTER key to save any	ENTER
changes and/or move to next.

7.When finished: press the ON/OFF key to exit. Then, press it to turn the display back ON. New settings will operate as set.

8f-05-02

0

30