[SENSe:]
TOTalize:SLOPe {NEGative|POSitive}[,(@<ch_list>)]
TOTalize:SLOPe? [(@<ch_list>)]
Configure the totalizer to count on the rising edge (default; positive) or
falling edge (negative) of the input signal. The totalizer channel is
numbered “s03”, where s represents the slot number. The :SLOP? query
returns the edge selection. Returns “NEG” or “POS”.
[SENSe:]TOTalize:CLEar:IMMediate [(@<ch_list>)]
Immediately clear the count on the specified totalizer channels.
The totalizer channel is numbered “s03”, where s is the slot number.
[SENSe:]TOTalize:DATA? [(@<ch_list>)]
Read the count on the specified totalizer channels. If you have selected
the RRESet parameter in the TOT:TYPE command, then the TOT:DATA?
command will reset the count to “0” after it is read. The count is reset
regardless of whether the specified channels are in the scan list or even
whether a scan is in progress. The maximum count is 67 ,108,863 (226-1).
The count rolls over to “0” after reaching the maximum allowed value.
The output from this command is affected by the FORMat:READing
commands (see “Reading Format Commands” on page 231). 5
Chapter 5 Remote Interface Reference
Totalizer Commands
257