Agilent Technologies 34970A manual Calibration Errors

Chapter 6 Error Messages

Calibration Errors

	Calibration Errors
	The following errors indicate failures that may occur during a calibration.
	Refer to the 34970A Service Guide for more information.
701	Cal: security disabled by jumper
	The calibration security feature has been disabled with a jumper inside
	the instrument. When applicable, this error will occur at power-on to
	alert you that the instrument is unsecured.
702	Cal: secured
	The instrument is secured against calibration.
703	Cal: invalid secure code
	You have entered an invalid calibration security code. You must use the
	same security code to unsecure the instrument that was used to secure it,
	and vice versa. The security code may contain up to 12 alphanumeric
	characters. The first character must be a letter, but the remaining
	characters can be letters, numbers, or an underscore ( _ ). You do not have
	to use all 12 characters but the first character must always be a letter.
	The security code is set to “HP034970” when the instrument is shipped
	from the factory.
704	Cal: secure code too long
	The security code may contain up to 12 alphanumeric characters.
	A security code was received which contained more than 12 characters.
705	Cal: aborted
	A calibration in progress is aborted when you turn off the instrument or	6
	send a bus Device Clear.
706	Cal: value out of range
	The specified calibration value (CALibration:VALue) is not valid for
	the present measurement function and range.
707	Cal: signal measurement out of range
	The specified calibration value (CALibration:VALue) does not match
	the signal applied to the instrument.
708	Cal: signal frequency out of range
	The input signal frequency for an ac calibration does not match the
	required input frequency for this calibration.
709	Cal: no cal for this function or range
	You cannot perform calibrations for most ac current ranges, the 100 MΩ

resistance range, and period.

315