ESG Family Signal Generators |
| Init ignored; Unable to sweep due to sweep being in an error |
| state. The sweep error should be fixed. |
| The number of list, power, and/or dwell points are in conflict, or a serious |
| system error has occurred in list/sweep. A previous error report should |
| have described the error that is stalling list/sweep. |
| Arm ignored |
| An arming signal was received and recognized by the device but was |
| ignored. |
| Trigger ignored |
| A GET, *TRG, or triggering signal was received and recognized by the |
| device, but was ignored because of device timing considerations. For |
| example, the device was not ready to respond. |
| Trigger error |
| A GET,*TRG, or a triggering signal could not be executed due to an error. |
| Settings lost due to rtl |
| A setting associated with a hard local control (see IEEE 488.2, 5.6.15) was |
| lost when the device changed to LOCS from REMS or to LWLS from |
| RWLS. |
| Invalid while in local |
| A command is not executable while the device is in local mode due to a |
| hard local control (see IEEE 488.2, 5.6.1.5). For example, a device with a |
| rotary switch receives a message which would change the switch’s state, |
| but the device is in local so the message cannot be executed. |
| Execution Error |
| For devices that cannot detect more specific errors, this code indicates only |
| that an execution error as defined in IEEE 488.2, 11.5.1.1.5 has occurred. |
Execution Error; Cannot transmit paging message to FlexDG.
There is an error with the cdma2000 hardware. Try turning CDMA2000 mode off and on again to reset the card. If the problem persists, report this error to the nearest Agilent Technologies sales or service office.
Error Messages | 47 |
