ESG Family Signal Generators

-299 to -200: Execution Errors

Settings conflict; RSCH is only defined for Radio Configuration 1 and 2. You must set one of these Radio Configurations before configuring or using this code channel.

The command attempted to enter a value or setting for the R-SCH in RC1 or 2. If this is the correct R-SCH, change to the desired radio configuration and resend the command. If not, select the command for the desired R-SCH. Use the following list to determine the correct R-SCH command to use:

R-SCH

Used in RC1 and 2

R-SCH1

Used in RC3 and 4 for channel 4

R-SCH2

Used in RC3 and 4 for channel 2

Refer to chapter 5 in the Option 201 user’s and programming guide for more information.

Settings conflict; RSCH1 is only defined for Radio Configuration 3 and 4. You must set one of these Radio Configurations before configuring or using this code channel.

The command attempted to enter a value or setting for the R-SCH1 in RC3 or 4. If this is the correct R-SCH, change to the desired radio configuration and resend the command. If not, select the command for the desired R-SCH. Use the following list to determine the correct R-SCH command to use:

R-SCH

Used in RC1 and 2

R-SCH1

Used in RC3 and 4 for channel 4

R-SCH2

Used in RC3 and 4 for channel 2

Refer to chapter 5 in the Option 201 user’s and programming guide for more information.

Settings conflict; RSCH2 is only defined for Radio Configuration 3 and 4. You must set one of these Radio Configurations before configuring or using this code channel.

The command attempted to enter a value or setting for the R-SCH in RC3 or 4. If this is the correct R-SCH, change to the desired radio configuration and resend the command. If not, select the command for the desired R-SCH. Use the following list to determine the correct R-SCH command to use:

R-SCH

Used in RC1 and 2

R-SCH1

Used in RC3 and 4 for channel 4

R-SCH2

Used in RC3 and 4 for channel 2

Refer to chapter 5 in the Option 201 user’s and programming guide for more information.

Error Messages

43

Page 45
Image 45
Agilent Technologies E4400-90333 manual Used in RC1, Used in RC3 and 4 for channel