ESG Family Signal Generators |
-399 to -300: Device-Specific Errors
Some device operations did not properly complete, possibly due to an abnormal hardware or firmware condition. These codes are also used for
A stop bit was not detected when data was received (for example, a baud rate mismatch).
The parity bit was not correct when data was received (for example, an incorrect parity bit on a serial port).
This is the generic communication error for devices that cannot detect the more specific errors described for errors
This is a specific code entered into the queue in lieu of the code that caused the error. This message indicates that there is no more room in the queue and an error occurred but was not recorded.
The device has detected a failure during its calibration procedure.
The device has detected a failure during its self-test procedure.
The data generator memory failed. Modulation data produced by the data generator may not be correct. An address that appeared to have a failed address line was reported. Report this error to the nearest
Agilent Technologies sales or service office.
6 | Error Messages |
