Agilent Technologies E4400-90333 manual Values, 314, 313, 312, 311, Catalog, 310

-399 to -300: Device-Specific Errors ESG Family Signal Generators

Configuration memory lost; Persistent state checksum is bad. Using factory defaults.

The persistent state is corrupt and had to be reinitialized with the factory preset values.

Configuration memory lost; Persistent state preset. Using factory defaults.

The persistent state has been forced to return to factory preset values.

	Configuration memory lost; Persistent state version is bad.
	Using factory defaults.
	The persistent state version is not recognized as valid and is assumed to
	be corrupt. The persistent state is reinitialized with the factory preset
	values.
-314	Save/recall memory loss
	The non-volatile data saved by the *SAV? command has been lost.
-313	Calibration memory lost
	Indicates that non-volatile calibration data has been lost.
-312	PUD memory lost
	The protected user data saved by the *PUD command has been lost.
-311	Memory error
	An error was detected in the device’s memory.
	Memory error; Unable to configure Save Recall registers from
	non-volatile memory. Save Recall registers re-initialized.
	Indicates that saved states are no longer usable. Delete explicitly using
	Catalog.
-310	System error; Absolute I and Q voltages must be at most
	1 volt.

An internal error has occurred that results in the normalized I or Q voltage to be greater than 1 volt. Report this error to the nearest Agilent Technologies sales or service office.

14 Error Messages