Aiwa Z-L70 Press CLOCK 2 Within 4 seconds, turn MULTI JOG to designate, the hour and the minute

To add a reservation during play

Repeat step 3.

To check the reserved tracks

Press CD EDiT/CHECK repeatedly. Each time it is pressed, the disc number and track number are displayed in the reserved order.

To stop play

Press ■ . When + F is pressed, the play starts from the last track again.

To skip a track

Press -.

The skipped track is cleared from the program.

To clear all the reservations

In stop mode, press - repeatedly until “K- POO”is displayed.

Press it once more to cancel the Karaoke programs. The display returns to that of CD play.

. If the reserved track number does not exist on the selected disc, the unit stops playing and the display flashes.

In this case, press > to skip the error track. Then press ● - to start play with the next reserved track.

●When PRGM is pressed twice in step 2, “--0:00” is displayed and the unit enters CD programmed play mode (page 17). To cancel programmed play, press ■ .

CLOCK

II

4,*

When the clock is set, the “:”between the hours and minutes flashes. When the power cord is plugged into an AC outlet for the first time after purchase or when the clock setting is canceled due to a power failure, the entire clock display flashes.

1Press CLOCK.

2Within 4 seconds, turn MULTI JOG to designate

the hour and the minute.

Turning MULTI JOG changes both the hour and the minute.

-or - is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

3 Press ENTER or Il.

The clock starts from 00 seconds.

To view the clock when another display is in the display

Press CLOCK. The time is displayed for 4 seconds and then the original display reappears. However, the clock cannot be displayed during recording.

To switch to the 24-hour standard

Press CLOCK and then press ■ within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

If the display flashes when the clock is displayed, it indicates that the clock has stopped due to a power failure or the removal of the power cord. The current time needs to be reset.

If the power-economizing mode (page 7) is on, all the display lights turn off when the power is turned off. To view the clock, press CLOCK so that the time is displayed for 4 seconds.

24 ENGLISH