Using your Web Browser
To establish a connection from your PC to the Wireless Router:
1.After installing the Wireless Router in your LAN, start your PC. If your PC is already running, restart it.
2.Start your WEB browser.
3.In the Address box, enter “http://” and the IP Address of the Wireless Router, as in this example, which uses the Wireless Router's default IP Address: http://192.168.1.1.
If you cannot connect
If the Wireless Router does not respond, check the following:
The Wireless Router is properly installed, LAN connection is OK, and it is powered ON. You can test the connection by using the “Ping” command:
❑Open the
❑Enter the command: ping 192.168.1.1 If no response is received, either the connection is not working, or your PC's IP address is not compatible with the Wireless Router's IP Address. (See below.)
❑If your PC is using a fixed IP Address, its IP Address must be within the range 192.168.1.2 to 192.168.1.254 to be compatible with the Wireless Router's default IP Address of 192.168.1.1. Also, the Network Mask must be set to 255.255.255.0. Refer to Chapter 4, PC Configuration on page 47 for details on checking your PC's TCP/IP settings.
❑Ensure that your PC and the Wireless Router are on the same network segment. (If you don't have a router, this must be the case.)
❑Ensure you are using the wired LAN interface. The Wireless interface can only be used if its configuration matches your PC's wireless settings.
31
