Allied Telesis AT-WA1004G manual Using a Special Application Multi-DMZ, Outgoing Ports

Advanced Features

Outgoing Ports

❏Type - Select the protocol (TCP or UDP) used when you send data to the remote system or service.

❏Start - Enter the beginning of the range of port numbers used by the application server, for data you send to it. If the application uses a single port number, enter it in both the “Start” and “Finish” fields.

❏Finish - Enter the end of the range of port numbers used by the application server, for data you send to it. If the application uses a single port number, enter it in both the “Start” and “Finish” fields.

Using a Special Application

Multi-DMZ

❑Configure the Special Applications screen as required.

❑On your PC, use the application normally. Remember that only one PC can use each Special application at any time. Also, when one PC is finished using a particular Special Application, there may need to be a “Time-out” before another PC can use the same Special Application. The “Time-out” period may be up to 3 minutes.

Note

If an application still cannot function correctly, try using the “DMZ” feature.

This feature, if enabled, allows the DMZ computer or computers on your LAN to be exposed to all users on the Internet.

❑This allows almost any application to be used on the “DMZ PC”.

❑The “DMZ PC” will receive all “Unknown” connections and data.

❑If the DMZ feature is enabled, you must select the PC to be used as the “DMZ PC”.

If you have multiple Internet IP addresses, you can assign one DMZ PC for each Internet IP address.

If you only have one WAN IP address, only “DMZ 1” can be used, and only one PC can be the DMZ PC. The current WAN IP address is displayed. If this address is assigned upon connection, and no connection currently exists, then this address will be blank or 0.0.0.0.

96