Alpine PXA-H800 Before Performing Automatic Measurement, Naming the AUX Input AUX Name, 16-EN

From a PC

Naming the AUX Input (AUX Name)

When you connect an external input source, you can name it with a suitable name (Initial setting: “Auxiliary”).

1 Click [ ] for each AUX and select and click the external input product name from the pull-down menu.

Setting item: AUX Name

Setting contents: Auxiliary/TV/EXT.DVD/Portable/Game

•This item becomes possible to set only when AUX IN setting is on.

Setting/Adjusting the Navigation Guidance Volume (Navi Mix)

If a navigation system is connected, its voice guidance will be mixed with the system and output from the front speakers (Initial setting: “OFF”). You can adjust the navigation guidance volume (Initial setting: “0 dB”).

1 Click [ON] or [OFF] for “Navi Mix” in the main menu.

If you click [ON], select the setting value.

2 Click [ ] or [ ] to adjust the volume.

Setting contents: -10 to +10 dB

•For details on the connection of a navigation system, refer to the installation manual.

Automatic

Measurement

Function

Before Performing Automatic

Measurement

This unit is equipped with ImprintEQ, RoadEQ, and AutoTCR automatic measurement functions.

WARNING

•Do not perform automatic measurement while the vehicle is running.

Automatic measurement requires microphones to be installed in the cabin to measure acoustic characteristics, and the speakers may output loud noise for measurement. This may interfere with safe driving and lead to an accident.

Be sure to read before performing automatic measurement.

•The automatic measurement should be performed in a quiet place with the engine, air-conditioner, and heater turned off. If a mobile phone or car phone is installed in the vehicle, move them outside of the cabin, or turn the power off. Sound other than the measuring sound (ambient noise around the vehicle, engine noise, and ringtones) may interfere with measurement, resulting in inaccurate measurement of the acoustic characteristics of the cabin.

•Be aware that the battery may be drained if you use the unit for an extended period of time without running the engine.

•The microphone supplied with this product is specifically designed for this type of measurement. Use of any other microphone will give poor or no results. Use of microphones other than the one supplied is not recommended.

•If the system is equipped with a power amplifier with input level control or a powered subwoofer, the measurement may not be possible if the input level is set low. However, to perform correct measurement, the input level should not be set too high.

•For a power amplifier with low-pass filter, turn off the low-pass filter of the power amplifier to make measurement. The low-pass filter in the powered subwoofer or the power amplifier for a subwoofer should be set at the highest cutoff frequency.

Measurement sequence for the automatic measurement functions

Perform the automatic measurement in the following sequence.

When ImprintEQ is used:

First, ImprintEQ, then RoadEQ.

When ImprintEQ is not used:

First, Auto TCR, then RoadEQ.

•When ImprintEQ is used, AutoTCR is not required.

•When ImprintEQ and AutoTCR are performed after RoadEQ, re- perform RoadEQ.

16-EN