From the Commander
Setting the Color for the Commander Illumination Button (ILLUMINATION)
You can change the lighting color of the buttons. (Initial setting: “BLUE”)
1 Press [FUNC.].
2 Rotate the [Rotary encoder] to select “Display Setup,” and then press the [Rotary encoder].
3 Rotate the [Rotary encoder] to select “ILLUMINATION,” and then press the [Rotary encoder].
4 Rotate the [Rotary encoder] to select “BLUE” or “RED.”
5 When the setting is complete, press and hold [ 
] for at least 2 seconds.
•If [ 
] is pressed during setting, the unit returns to the previous item.
•When “Manual” is selected, the brightness of the display does not change if you turn on the headlamps. This always sets the brightness at the level specified in “Adjusting the Brightness Level of the Display (Dimmer Level)” (page 58).
Adjusting the Brightness Level of the Display (Dimmer Level)
With the Dimmer control ON, three Dimmer levels are available. The highest, Level 3, being the most dim with the vehicle's headlights ON. (Initial setting: “Level 1”)
1 Press [FUNC.].
2 Rotate the [Rotary encoder] to select “Display Setup,” and then press the [Rotary encoder].
3 Rotate the [Rotary encoder] to select “Dimmer Level,” and then press the [Rotary encoder].
5 When the setting is complete, press and hold [ 
] for at least 2 seconds.
•If [ 
] is pressed during setting, the unit returns to the previous item.
Adjusting the Brightness of the Display (Dimmer)
Set the Dimmer control to “Auto” to decrease the illumination brightness of the unit with the head lights of the vehicle ON. This mode is useful if you feel the unit’s backlighting is too bright at night. (Initial setting: “Auto”)
1 Press [FUNC.].
2 Rotate the [Rotary encoder] to select “Display Setup,” and then press the [Rotary encoder].
3 Rotate the [Rotary encoder] to select “Dimmer,” and then press the [Rotary encoder].
4 Rotate the [Rotary encoder] to select “Auto” or “Manual.”
4 Select one from “Level 1” through “Level 3” by rotating the [Rotary encoder].
5 When the setting is complete, press and hold [ 
] for at least 2 seconds.
•If [ 
] is pressed during setting, the unit returns to the previous item.
