7.The display indicates the “OUTSIDE ACCESS?” prompt.
a.If you don't need to dial a number to access an outside line, press the Dial/ Enter button and go to Step 8.
b.Alternatively, enter the trunk access code (up to 4 digits), press the Dial/ Enter button and go to Step 8.
c.If you enter a trunk access code by mistake, press the Delete button or the ∀button to delete the digits.
The trunk access code will be automatically dialed prior to any number over 6 digits stored in the caller ID memory only.
Note: Numbers stored in the directory or as programmable keys will not have the trunk access code automatically dialed — you will need to include the trunk access code as part of the dialing stream when storing numbers to the directory or programmable keys.
A stored number with 6 or fewer digits is considered an internal extension number. A PAUSE period or 3 seconds delay is inserted automatically between the trunk access code and the phone number.
8.Press the Menu or Save button to save these operating settings and to exit the menu mode.
9.After installation, lift the telephone's Handset and listen for the dial tone. If there is no dial tone, check to make sure all cords are firmly plugged into their jacks.
Note: Programming your area code will allow you to easily dial numbers that are in your Caller ID list. See the Section “Calling Back a Number from the Caller ID List” for more information on dialing calls from your Caller ID list.
Wall Mounting
1.Turn the phone over so that you are looking at the bottom of the phone. Insert tabs at the thin end of the wall mount bracket into the holes at the rear of the phone bottom. Press and latch the tabs at the thicker end of the wall bracket into holes at the front end of phone. The back of the
