Operator Panel Reference
System Params.
Parameter | Values | Description |
Units | Inches or | Selects the units for |
| Millimeters | parameter values |
Media Alignment | Automatic or | Automatic: Printer will align |
| Manual | the label prior to printing first |
|
| label |
|
| Manual: Operator is |
|
| responsible for aligning label |
|
| start position |
ENTER to recall | - | ENTER |
|
| |
defaults |
| Pressing the PRINT key will |
| cause parameter values to | |
|
| |
|
| reset to default values |
|
|
|
ENTER to Select | - | ENTER |
|
| |
Diagnostics |
| Pressing the PRINT key will |
| bring the printer into the | |
|
| |
|
| sensor diagnostic mode. (see |
|
| Verifying the Sensor |
|
| Operation in the |
|
| Troubleshooting Guide) |
Firmware Part No. | - | The firmware part number |
XXXXXXYY |
| and revision are displayed |
|
|
|
Hex Dump Mode | ON or OFF | Printer will enter into Hex |
|
| Dump mode after the next |
|
| Power Cycle. (see Hex Dump |
|
| Mode in the |
|
| Troubleshooting Guide) |
Settings Label | - | ENTER |
|
| |
Press Enter Key |
| Pressing the PRINT key will |
| print the current parameter | |
|
| |
|
| value settings. |
|
|
|
44
