Quick Start Guide
Set Label Parameters
ONLINE
1. | Press the | PAUSE | key. This takes you to the |
|
|
|
|
| MENU |
2. | When Interface Status | key. This | ||
| will display the |
| ||
|
| MENU |
|
|
3. | Press the |
| key until the Label Parameters option is displayed. | |
|
| ITEM |
|
|
4. | Press the | FEED | key. Media Type is the first parameter displayed. The two | |
| options for this parameter are Direct Thermal and Thermal Trans. Press | |||
the 
or CANCEL key to change the option. If the printer has a ribbon installed select Thermal Trans. Otherwise select Direct Thermal.
ENTER
Complete the selection process by pressing the PRINT key. An asterisk (*) will appear in front of the selected option to indicate the value has been set.
5.Press the Use the
ITEM
FEED key again. Label Width is the next parameter displayed.
or CANCEL keys to set the value to the label’s width.
NOTE: When changing values using the 
or CANCEL keys, a single key press will change the value by one unit. If the key is pressed and held in, the value will change by 10 units.
ITEM
6. Press the FEED key again. Label Length is the next parameter. Use the
or CANCEL keys to set the value to the label’s length. This value does not include the Label Gap (see Figure 6). For label length information for other media types see this manual’s Media Settings section.
ITEM
7. Press the FEED key again. Label Gap is the next parameter. Use the
or CANCEL keys to set the value to the Label Gap length. If using black bar labels, set Label Gap to 0.01. If using continuous labels set the value to 0.00.
12
