Maintenance

Printhead Cleaning

Clean the printhead with every ribbon change or after every 10,000 linear inches of direct thermal label media. Use the cleaning pen supplied with the printer or a Q-tip soaked in alcohol. Three to four swipes along the heater line should be sufficient to remove any collected material (Figure 16)

!

WARNING: The printhead may be extremely HOT. Make sure the printer is off. Using inappropriate cleaning materials will damage the printhead.

To expose the printhead, find the PRESS HERElabel affixed to the Printhead Bracket. Press down where indicated and rotate the Printhead Lock Lever back to unlock the bracket. Swing the Printhead Bracket up and back to expose the paper path. Leave the Printhead Bracket in the up position for cleaning the paper path.

Heater

Line

Location

Figure 16 – Print Line Location on Printhead

Paper Path Cleaning

Using a lint-free cloth or compressed air, remove any dust and debris from the paper path beneath the printhead. Return the printhead to the original position.

Remove the label roll and clean the exposed surfaces. Clear all dust and debris from the paper guides paying close attention to the inside sensor block.

NOTE: Printers operating with high duty cycles or caustic environments should be examined daily for dust and debris build-up.

Reinstall media, apply power and return printer to operating status.

48

Page 58
Image 58
AMT Datasouth 4500 Series manual Printhead Cleaning, Paper Path Cleaning, Heater Line Location