Configuring
the GPIB The GPIB configuration menus let you perform the
following:
qSet the GPIB address and select the GPIB line
terminator for the signal generator.
qTurnon the source lock mode for operation
with a Model 360B VectorNetwork Analyzer.
qSelect the model and set the GPIB address for
the power meter used to create a user level
flatness correction power-offset table.
qSelect the external interface language for re-
mote operation of units with Option 19.
qSelect scalar mode of operation with a Hewlett
Packard Model 8757D Scalar Network Ana-
lyzer.
Togo to the Configure GPIB menu from the System
Configuration menu, press GPIB . The Configure
GPIB Menu (below) is displayed.
Press GPIB Address to change the address of the
681XXC on the bus (the signal generator’s default
GPIB address is 5). Enter a new address, between 1
and 30, using the cursor control key or the data en-
try keypad and the terminator key
Hz
ns
ADRS
The new GPIB address will appear on the display.
Press Line Term to select a carriage return (CR)or
a carriage return and line feed (CR/LF) as the GPIB
data delimiter.Consult the GPIB controller ’sman-
ual to determine which data delimiter is required.
681XXC OM 3-85LOCAL (FRONT SYSTEM
PANEL) OPERATION CONFIGURATION