Step 10 Place the right side inner slide assembly
onto the instrument case with the handle
towards the front of the instrument.
Step 11 Insert two green-headed screws through
the holes in the slide assembly behind the
handle and into the metric tapped holes
in the side of the instrument.
Step 12 Insert two green-headed screws through
the holes near the rear of the slide assem-
bly and into the metric tapped holes in
the side of the instrument.
Step 13 Insert the two SAE threaded screws (re-
moved from the feet) through the 90°tabs
on the rear of the slide assembly and into
the rear panel of the instrument.
Step 14 Using the Phillips screwdriver,tighten all
screws holding the right side slide assem-
bly to the instrument chassis.
Step 15 Withthe appropriate hardware, install
the outer slide assemblies onto the equip-
ment rack.
Step 16 Lift the signal generator into position.
Align the inner and outer slide assem-
blies and slide the instrument into the
rack. Realign the hardware as needed for
smooth operation.
2-12 681XXC OMRACK MOUNTING KIT
INSTALLATION INSTALLATION
Use two or more people to lift and move this equipment, or
use an equipment cart. There is a risk of back injury,if this
equipment is lifted by one person.
WARNING