DTAD SETUP
15 SEC
ANSWER DELAY
NOTE: For the auto attendant to work properly, you must make sure that the DTAD answer delay time is longer than the auto attendant answer delay time (page 49).
DTAD SETUP
ON
TOLL SAVER
NOTE: If the toll saver feature is ON, for the auto attendant to work properly, you must make sure that the
DTAD setup (1080 only)
Answer delay
Use this feature to set the length of time this phone rings before the answering system picks up the call. One ring cycle lasts about six seconds.
1.Press [ENTER].
2.Press [
] or [
] until you see DTAD SETUP. Press [ENTER].
3.Press [
] or [
] until you see ANSWER DELAY.
4.Press [
] or [
] to choose the desired setting
5.To move to the next feature, press [
].
To exit setup, press and hold [ENTER].
Toll saver
Use this feature to turn toll saver on or off. When toll saver is turned on, the answering system picks up incoming calls within eight seconds if there are any new private messages. When there are no new messages, the answering system picks up the incoming call in the time you set as the answer delay. (See Answer delay section above on this page for details).
To turn toll saver on or off:
1.Press [ENTER].
2.Press [
] or [ ] until you see DTAD SETUP. Press [ENTER].
3.Press [
] or [ ] until you see TOLL SAVER.
4.Press [
] or [
] to choose ON or OFF.
5.To move to the next feature, press [
].
To exit setup, press and hold [ENTER].
58
