ExpressNAV Pages | ATTO Technology VT-Class instruction

5.1 ExpressNAV Pages

Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters based on specific topics. Each page can be reached through the menu on the left hand side of each page.

Status

General information:

•Unit Information including Vendor ID, Product ID, Firmware Revision and Serial Number

•Environmental information

•World Wide Identifiers including Node Names and Port Names

•Host Interface Card Status

•Fan Status

•Power Supply Status

•Storage Status including ATA Disk Errors and Logical Unit Conflicts

Ethernet

Configures the Ethernet port. Configurable parameters are:

•IP Address

•IP Gateway

•IP Subnet Mask

•Ethernet Speed

• Use DHCP

See Ethernet Access: Telnet and SNMP Protocols on page 21 for details.

SNMP

Remote system monitoring is available using Simple Network Management Protocol (SNMP).

See Ethernet Commands on page 33 for details on each parameter.

Serial Port

Allows you to configure the serial port. Configurable options are Baud Rate and Echo

See Ethernet Access: Telnet and SNMP Protocols on page 21 for more information.

Fibre Channel

Manages the Fibre Channel port.

•Data rate

•Full duplex mode

•Connection mode

See Connecting a Fibre Channel Array on page 11 for more information.

Storage Management

Displays information about the drives and their status including

•Sled Number

•Capacity of each sled

•Number of errors

•Type of configuration (RAID level)

•Virtual Disk ID

You may place sleds on or off line by selecting or de- selecting a check box.

See Drive Management Commands on page 41 for more information.

Once you open this page, other configuration pages are available on the menu on the left hand side of the page.

RAID

Configures RAID groups. Information provided includes

•Type of configuration (RAID level)

•Virtual Disk ID

•Number of partitions

•State of sleds

•Capacity of sleds

•Interleave values

Configurable options are:

•RAID Level

•Number of tape volumes

•Number of tape drives

•Hot Spare sleds

From the RAID page, go to RAID Rebuild

Configuration to change

•Interleave

•Rebuild state

•Enable/disable auto rebuild

See Configuring the Diamond-VTon page 47 for more information.

Clear Data

•view the status of any Clear Data command

•view the rebuild state of each sled

•initiate a RAID Level 5 Clear Data command