6.7 Diagnostic Commands
Diagnostic commands provide information or diagnostic tools for Fibre Channel, SCSI and Serial port configurations, Diamond Storage Array settings and the status of various commands which affect the ATA drives.
AudibleAlarm
Enables or disables the audible alarm in the Diamond Storage Array. When enabled, an alarm sounds when the Fault LED on the front panel blinks.
Default: disabled
Set syntax: set AudibleAlarm [enabled disabled]
Get syntax: get AudibleAlarm
DiamondModel
Returns specific Diamond Storage Array model information including firmware release and date.
Get syntax: get DiamondModel
DiamondName
Used to identify this Diamond over its Fibre Channel and Ethernet networks. You may customize the name of each Diamond Storage Array enclosure to distinguish it from other units. Maximum eight characters.
Set syntax: set DiamondName [name]
Requires a SaveConfiguration command
Get syntax: get DiamondName
FcPortList
Lists the status of all available Fibre Channel ports.
Immediate command: FcPortList
FcPortName
Returns the Fibre Channel port name stored in NVRAM for this Fibre Channel port.
Get syntax: get FcPortName [port number]
Help
Displays a list of available commands. Type ‘help’ followed by a command name to display detailed
Get syntax: Help [Command Name]
IdentifyDiamond
Enable this option to identify the current Diamond Storage Array. The fault LED on its front panel blinks. Disable to cancel the ‘blink code.’
Set syntax: set IdentifyDiamond [enableddisabled]
Get syntax: get IdentifyDiamond
DriveCopyStatus
Displays the status of a DriveCopy, DriveWipe or RAID5ClearData operation
Immediate command: DriveCopyStatus
DriveInfo
Displays information about all disk drives or detailed information about a specific disk drive. Detailed information about an individual drive is obtained by supplying a drive identifier. VD ID is Virtual Disk ID.
Get syntax: DriveInfo [sled ID] [drive ID]
FcNodeName
Returns the Fibre Channel node name stored in NVRAM for this Fibre Channel port: the same as the World Wide Name for port 0.
Get syntax: get FcNodeName
FcPortInfo
Retrieves information about the current state of each Fibre Channel port. The status field indicates ‘disabled’ when a port has been internally disabled.
Immediate command: FcPortInfo
39
Info
Displays version numbers and other key information about the Diamond Storage Array including data rate, connection mode, WorldWideName, Diamond Storage Array name.
Immediate command: Info [all]
LUNInfo
Displays information about all LUNs (logical unit numbers) or detailed information about a specific LUN. Do not specify a LUN to get information about all LUNs. Specify a LUN to get detailed information about that individual LUN.
Get syntax: get LUNInfo [LUN]
PartitionInfo
Displays Partition information for the selected partitions or all partitions.
Get syntax: PartitionInfo [activeplanned] [Virtual Drive ID] [Partition ID]
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
