ATTO Technology VT-Class Serial Port Configuration Commands, SerialPortBaudRate, SerialPortEcho

6.5 Serial Port Configuration Commands

The serial port configuration may be customized by using the following commands:

SerialPortBaudRate

Sets the baud rate the Diamond Storage Array uses for its terminal interface. Choices are 2400, 9600, 19200, 38400, 57600, 115200.

Default: 115200

Set syntax: set SerialPortBaudRate [2400 9600 19200 38400 57600 115200]

Get syntax: get SerialPortBaudRate

SerialPortHandshake

Describes which handshaking method the Diamond Storage Array uses for its terminal interface (hardware, Xon/Xoff or none). Choices are hardware, Xon or none

Default: none

Set syntax: set SerialPortHandshake [hard Xon none] Requires a SaveConfiguration Restart command Get syntax: get SerialPortHandshake

SerialPortEcho

Controls whether the Diamond Storage Array echoes characters on its RS-232 port. Local ASCII terminal (or terminal emulator) echo settings should be set to disabled while in serialportecho enabled

Default: disabled

Set syntax: set SerialPortEcho [enabled disabled] Requires a SaveConfiguration Restart command Get syntax: get SerialPortEcho

SerialPortStopBits

Configures/reports the number of stop bits per character for the Diamond Storage Array RS -232 serial port. The number of data bits per character is fixed at 8 with no parity. Choices are 1 or 2 stop bits

Default: 1

Set syntax: set SerialPortStopBits [1 2] Requires a SaveConfiguration Restart command Get syntax: get SerialPortStopBits

37

ATTO Technology Inc.