ATTO Technology VT-Class manual Resetting Defaults, Factory Default, Return to Default settings

Diamond-VT.

63

ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual

9.2 Resetting Defaults

Resetting the Diamond-VT to defaults will not alter the RAID configuration, zoning configuration, IP configuration or Telnet information. However, resetting the Diamond-VT to factory defaults is a last-ditch effort to recover from corrupt configurations or complete failure. All data will be lost, but the zoning configuration will remain.

4 Reboot the host PC after the Diamond-VT

CAUTION	completes its power on cycle.
Data will be lost if you follow these
	Factory Default
procedures. Make sure you have no other
	Resetting the Diamond-VT to factory defaults is a last-
choice before resetting the Diamond-VT to
factory defaults.	ditch effort to recover from corrupt configurations or
Default	complete failure. All data will be lost.
If you need to return to the default settings of the	Note
Diamond-VT but do not want to lose data or Ethernet
	Using RestoreConfiguration default or
settings, use the CLI command RestoreConfiguration
	RestoreConfiguration factory default will not
default in CLI mode or in the Advanced CLI
	affect the zoning configuration. To restore the
configuration page of the ExpressNAV interface.	Diamond-VT to factory default, type
Note	ZoneClearAll
	ZoneCommit
Using RestoreConfiguration default or
	To reset to Factory Defaults, firmware version
RestoreConfiguration factory default will not
affect the zoning configuration. To restore the	2.5.3 or higher
Diamond-VT to factory default, type	1 Connect to Diamond-VT services via the RS-232
ZoneClearAll	port or the optional Ethernet management
ZoneCommit	services card (see Accessing the Diamond-VT on
Return to Default settings	page 15). You should now be in Command Line
	Interface.
1 Connect to Diamond-VT services via the RS-232	2 Continue with the CLI or access the ExpressNAV
port or the optional Ethernet management	interface (see ATTO ExpressNAV: Browser-based
services card (see Accessing the Diamond-VT on	Interface on page 23).
page 15). You should now be in Command Line	Note
Interface. Continue with the CLI or access the
ExpressNAV interface (see ATTO ExpressNAV:	Because the ExpressNAV pages take you
Browser-based Interface on page 23).	through this process easily, the following
Note	instructions are based on the CLI commands.
	Use these instructions as a guide in ExpressNAV.
Because the ExpressNAV pages take you
	3 Type RestoreConfiguration factorydefault to reset
through this process easily, the following
	the system configuration. (See Exhibit 9.2-2for a
instructions are based on the CLI commands.
	list of configurations which will be changed).
Use these instructions as a guide in ExpressNAV.
	4 Type FirmwareRestart or cycle the Diamond-VT
2 Type RestoreConfiguration default to reset the
	power.
system configuration (See Exhibit 9.2-2for a list of
	5 Reboot the host PC after the Diamond-VT
configurations which will be changed).
	completes its power on cycle.
3 Type FirmwareRestart or cycle power of the