Chapter 10
Basic Switch Configuration
Introduction
This chapter describes the parameters you can define for the chassis, such as its name and location, time parameters, and so on.
Use the CLI commands briefly described below for configuring the display on your terminal or workstation.
In order to... | Use the following command... |
|
|
|
|
Open a CLI session to a P330 | session |
module in the stack, ATM or WAN |
|
expansion modules and Media |
|
Gateway Processor of G700. |
|
|
|
Display or set the terminal width | terminal width |
(in characters) |
|
|
|
Display or set the terminal length | terminal length |
(in lines) |
|
|
|
Display or set the prompt | hostname |
|
|
Return the prompt to its default | no hostname |
value |
|
|
|
Clear the current terminal display | clear screen |
|
|
Set the number of minutes before | set logout |
an inactive CLI session |
|
automatically logs out |
|
|
|
Display the number of minutes | show logout |
before an inactive CLI session |
|
automatically times out |
|
|
|
Access Layer 3 configuration if not | configure |
logged in as supervisor (see “User |
|
Authentication“ chapter) |
|
|
|
Avaya | 49 |
