Manuals / Avaya / Computer Equipment / Network Router

Avaya P332G-ML manual Configuring the P330 for MAC Aging, MAC Aging CLI Commands

Models: P332G-ML

1 150

Download 150 pages 40.92 Kb

Page 83

Chapter 11 Avaya P330 Layer 2 Features

MAC Aging

Overview

The MAC Aging feature allows the user to configure a time interval after which unused entries in the MAC Table will be deleted.

Configuring the P330 for MAC Aging

This section describes the configuration of the P330 for the MAC Aging functionality.

•MAC Aging is configured on the stack level.

•MAC Aging can be globally enabled/disabled using the set mac-agingcommand.

—After firmware upgrade to version 4.0, MAC Aging default state is disabled.

—After NVRAM INIT, MAC Aging default state is enabled.

•“mac-aging-time” is set in minutes:

—Default=5 minutes

—Minimum time=1 minute; maximum time= 3600 min

Note: On a mixed P330/P330-ML stack, MAC Aging—if enabled—will apply only to P330-ML modules in the stack.

MAC Aging CLI Commands

The following table contains a list of the CLI commands for the MAC Aging feature. The rules of syntax and output examples are all set out in detail in the P330 Reference Guide.

Table 11.4 MAC Aging CLI Commands

In order to...	Use the following command...


Enable/Disable MAC Aging	set mac-aging

Set the MAC aging time in minutes	set mac-aging-time
(0=don’t age).

Display the current status of the	show mac-aging
MAC aging function

Display the MAC aging time in	show mac-aging-time
minutes.

Avaya P332G-ML User’s Guide

69

Image 83

Avaya P332G-ML manual Configuring the P330 for MAC Aging, MAC Aging CLI Commands

Contents

Avaya P332G-ML Page Table of Contents Section Installing the P330 Section Configuration of the P330 LAG Bootp Section Troubleshooting and Maintaining the P330 Avaya P332G-ML User’s Guide Vii Table of Contents Viii Avaya P332G-ML User’s Guide CLI Conventions Before you InstallSafety Information FCC Notice Conventions Used in the DocumentationP332GAvaya P332G-ML User’s Guide Overview of the P330 Page About the P332G-ML Avaya P332G-ML OverviewIntroduction Network Management and Monitoring Layer 3 Features P330-MLCommand Line Interface CLI Avaya P332G-ML HighlightsPort Mirroring Avaya Multi-Service Network Manager MsnmFans, Power Supply and BUPS-ML Monitoring Avaya P332G-ML Overview Avaya P332G-ML User’s Guide Ietf Layer Standards and CompatibilityAvaya P330 Standards Supported Ietf Network Monitoring Physical SpecificationsP332G-ML Switch Power RequirementsEMC Emissions SafetySafety AC Version Safety DC VersionTable B.1 Stacking Sub-module Stacking Sub-moduleInterfaces Basic MtbfUsage Restriction Safety InformationApproved SFF/SFP Gbic Transceivers Laser ClassificationLX Transceiver InstallationInstalling and Removing a SFF/SFP Gbic Transceiver SpecificationsTable B.2 Gigabit Fiber Optic Cabling Gigabit Fiber Optic CablingAgency Approval Console Pin Assignments Connector Pin AssignmentsChapter Avaya P332G-ML User’s Guide Installing the P330 Page Environmental Prerequisites InstallationRequired Tools Site PreparationPower Requirements DC Power Requirements ACP332G-ML Rack Mounting Rack Mounting OptionalConnecting Stacked Switches Installing the X330STK-ML Stacking Sub-Module OptionalIncorrect Stack Connection To connect stacked switchesP330 Stack Connections Prerequisites Connecting Cables to Network EquipmentMaking Connections to Network Equipment ELX Powering On Avaya P330 Module DC Powering Up the Avaya P330Powering On Avaya P330 Module AC Post-Installation Avaya P332G-ML Front Panel Avaya P332G-ML Front and Rear PanelsLED Name Description LED Status Full Duplex mode Always ON. All ports are full-duplex onlyLAG Avaya P332G-ML Back Panel BUPS-ML Input Connector Sticker BUPS-ML Input ConnectorPage Establishing a Serial Connection Configuring the Terminal Serial Port ParametersConnecting a Terminal to the Avaya P330 Serial port Assigning P330’s IP Stack Address P330 SessionsAt the prompt, type Establishing a Telnet ConnectionOverview Connecting a Modem to the Console PortEstablishing a Modem PPP Connection with the P330 Security Levels User AuthenticationExiting the Supervisor Level Entering the Supervisor LevelDefining new local users Introduction to Radius Entering the CLIRadius Authentication Procedure Radius Commands Allowed Managers Allowed Manager CLI CommandsConfiguration of the P330 Page Avaya P330 Default Settings Default Settings of the P330Configuring the Switch Default Settings of the P330 Chapter Default Settings of the P330 Default Settings of the P330 Avaya P332G-ML User’s Guide Basic Switch Configuration Operating parameters System Parameter ConfigurationIdentifying the system UTC Network Time Acquiring Protocols Parameter ConfigurationBasic Switch Configuration Avaya P332G-ML User’s Guide Ethernet Avaya P330 Layer 2 FeaturesOverview Configuring Ethernet Parameters MAC Address Flow ControlPriority CAM Table Ethernet Configuration CLI CommandsConfiguration CLI Commands for Ethernet Feature Ethernet Implementation in the Avaya P332G-ML Vlan Overview Vlan ConfigurationMulti Vlan Binding Vlan TaggingIllustrates these binding modes in P330 Ingress Vlan Security Automatic Vlan LearningVlan CLI Commands Vlan CLI CommandsVlan Implementation in the Avaya P332G-ML Spanning Tree per Port Spanning Tree ProtocolSpanning Tree Protocol Port Roles Rapid Spanning Tree Protocol RstpAbout the 802.1w Standard Spanning Tree Implementation in the P330 Family Spanning Tree Protocol CLI Commandss Spanning Tree Protocol CLI CommandsSpanning Tree Protocol CLI Commandss MAC Aging Configuring the P330 for MAC AgingMAC Aging CLI Commands MAC Aging CLI CommandsLAG Overview LAG CLI CommandsLAG CLI Commands LAG Implementation in the Avaya P330 Family of Products Port Redundancy Operation Port RedundancyIntermodule Port Redundancy Port Redundancy CLI CommandsRedundancy CLI Commands check spec Avaya P330 Layer 2 Features IP Multicast Filtering IP Multicast Implementation in the Avaya P332G-ML IP Multicast CLI CommandsIP Multicast CLI Commands Weighted Queuing CLI Commands Weighted QueuingImplementation of Weighted Queuing in the P330-ML Weighted Queuing CLI CommandsWeighted Queuing CLI Commands Implementation of Stack Health in the P330 Family Stack Health CLI CommandsStack Health CLI Command Stack HealthPort Classification Port Classification CLI CommandsStack Redundancy Avaya P330 Layer 2 Features Avaya P332G-ML User’s Guide What is Routing? Avaya P330 Layer 3 FeaturesRouting Multinetting Multiple Subnets per Vlan Routing ConfigurationForwarding IP Configuration CLI Commands IP ConfigurationAssigning Initial Router Parameters Obtaining and Activating a License Key Create the management/routing VLAN. Use the commandObtaining a Routing License Key Activating a Routing License Key License Key CLI Commands RIP Overview RIP Routing Interchange Protocol ConfigurationDIfferences Between RIP and RIP2 RIP CLI CommandsAvaya P330 Layer 3 Features Ospf Overview Ospf Open Shortest Path First ConfigurationOspf CLI Commands Static Routing Overview Static Routing ConfigurationRoute Preferences Static Routing Configuration CLI CommandsRIP Route Redistribution Route Redistribution CommandsARP Overview ARP Address Resolution Protocol Table ConfigurationARP Table ARP CLI CommandsDHCP/BOOTP Relay BOOTP/DHCP OverviewBOOTP/DHCP CLI Commands NetBIOS Re-broadcast Configuration CLI Commands NetBIOS Re-broadcast ConfigurationNetBIOS Overview Vrrp Overview Vrrp Virtual Router Redundancy Protocol ConfigurationCase#1 Vrrp Configuration ExampleCase #2 Vrrp CLI CommandsAvaya P332G-ML User’s Guide 109 Srrp Overview Srrp ConfigurationSrrp Configuration Example Srrp CLI Commands Policy Configuration Overview Policy ConfigurationPolicy Configuration CLI Commands Avaya P330 Policy Policy Configuration ExampleP330-1super#ip access-list 100 2 fwd3 tcp any host IP Fragmentation/Reassembly CLI Commands IP Fragmentation and ReassemblyIP Fragmentation and Reassembly Overview Layer 3 Configuration File Avaya P330 Layer 3 Features 118 Avaya P332G-ML User’s Guide System Requirements Embedded Web ManagerEmbedded Web Manager/Browser Compatability Running the Embedded Web ManagerWelcome Web-based Manager Install from your Local Web Site Installing the Java Plug-inInstall from the Avaya Site 124 Avaya P332G-ML User’s Guide P330 Page Power supply is not user-replaceable Troubleshooting the InstallationTroubleshooting the Installation Page Replacing the Stacking Sub-module MaintenanceChapter Maintenance 130 Avaya P332G-ML User’s Guide Obtain Software Online Downloading Software Updating the SoftwareSoftware Download Download New Version without Overwriting Existing Version United States How to Contact UsUAE AP Asia Pacific Region 136 Avaya P332G-ML User’s Guide