| 49 |
Page / Event - Tab 7 |
3
4
5
6
3. Level:
Set the Volume desired for this event. When the event is triggered, the volume will be switched to this level in any zone set to respond to the page/event. Built in intelligence "remembers" the previous state the zone was in before the Page/Event occurred thereby returning the zone or zones to their previous state.
4. Turn Off Delay:
Adjust the time for which the Page/Event will remain on. If a voltage is momentarily sensed, the Page/Event will last for the time selected. The Page/Event will stay active as long as a voltage is preset, the timer starts from the time the voltage is dropped. Use Forever (slide bar all the way to the right) if you don't want the event to end until the user manually selects a new input or a new volume setting. If using Audio or video sensing, adjusting the delay will affect how long the CT will wait before terminating the event once the signal is lost.
5. Event Affects Control Out and Flasher Outputs:
Yes - When the event activates, the flasher outputs will change their routed location to the output designated by the page/event input selection. Control outputs would also be triggered for specified inputs.
No - The control and IR flashers will stay in the last selected state. Thus, if the client were just watch- ing a DVD, they may still use the DVD remote to pause the DVD. (Default set NO).
6. Page Event 2:
Sets up in the same way as Page/Event 1.
B & K
S I M P LY B E T T E R !
