B&K CT610, CT600 Menu Items for a Dedicated Input, Zones Menu, Zone Menu when set to MONO, B & K

	69
Audio / Video Submenu

SETUP INPUT F

1	Name	IN F 1.
2	Level	0dB
3	Mode	Stereo
4	Video	Yes	2.
5	Selection	Auto
6	Turn Off Delay	5sec
	↑↓ next item	adjust ←→

MENU main menu

Menu Items for a Dedicated Input

When a dedicated input is used, select Auto if the

CT Receiver should detect and automatically select the dedicated input when audio or video is detected.

Select a adequate amount of turn off time, typically 20-25 seconds if there is no video from this source, 0-5 seconds if this is a video source, or “Forever” if you don't want the input to return to the previous source once the input signal is lost.

			Zones Menu
			First select which of the six zones you want to configure.
	SETUP ZONE A AUDIO		Then do the following steps:
1	Mode	Stereo 1.	Set the zone for stereo or mono depending on the
2	Page/Event	2	requirements. If it is set to stereo, go to the next menu
3	User Tuner	1	screen description.
4	Level Control	Variable 2.	Page/Event - Select if this zone should respond to
5	Max Level	-6dB	common control 1, 2, both or none.
6	Left Calibration	0dB 3.	Assign a tuner the zone will use. (Tuner 1 or 2).
7	Right Calibration	0dB 4.	Level Control - Set this to VARIABLE for standard
	↑↓ next item	adjust ←→	adjustable volume via keypads and remote controls. Set
			this to FIXED if this zone uses impedance matching

MENU main menu	volume controls for background music or if you want it
	set to a fixed output level.

5.Max Level - Set this to the maximum level the zone is to be able to achieve. Typically, a variable max volume is set to -6 dB, the amplifier will not clip with a normal CD at this volume. Typically, fixed lev- els are set lower for impedance matching volume controls (between -25 & -10dB).

6.Left Calibration - Use this to permanently compensate for odd speaker placement or the relative dif- ference between linked zones.

7.Right Calibration - Same as Left Calibration.

	SETUP ZONE A AUDIO
1	Mode	Mono
2	Page/Event	2
3	User Tuner	1
4 Left Level		Variable
5	Left Max Level	-6dB
6	Right Level	Variable
7	Right Max Level	0dB
	↑↓ next item	adjust ←→
	MENU main menu

Zone Menu when set to MONO

(the Zone is SPLIT into two independent areas)

When a zone is set to mono, the zone can operate sim- ply as a mono zone or you have the ability to separate the left and right sides of the zone independently. When a zone is split to mono you are given independent con- trol of power, volume & mute for the right and left sides of the zone. You must share input (tuner), bass treble and loudness across the mono zone. You may also set the amp channels to a fixed volume level using this menu.

Split mono zone’s do not have the capability to calibrate as in stereo mode, however each side of the chan- nel can have a maximum volume limit specified.

B & K

S I M P LY B E T T E R !