Baldor AE11, AE10, AE25, AE8 manual 3 Troubleshooting Guide Analog Controller Only, Service, Parts

Note: See Engine Controller manual for additional information.

Table 5-3 Troubleshooting Guide (Analog Controller Only)

Problem	Possible Cause	Remedy
Controller cannot be	Engine not stopped	Verify the engine is at a complete stop before trying to reset.
	Controller not in OFF mode	Set the controller to the OFF mode before trying to reset.
Engine alarms are ON for high engine	Sending unit is disconnected (open	Verify the sending units wiring to controller terminals is not open or
temperature or low oil pressure when	circuit)	shorted.
engine is operating properly	Defective sending unit	Verify the engine mounted senders have correct resistance values
		for corresponding input temperature or pressure.

Overspeed shutdown occurs at normal speed

Controller has failed or input from Magnetic pickup is incorrect.

Verify the adjustments. Replace controller if failed.

Service	Service for your generator can be obtained from Baldor Generators. Please have the following
	information available prior to contacting the factory:
	The model number and serial number of the generator set.
	A complete and accurate description of the problem.
Parts	Parts for your generator can be obtained from Baldor Generators. Please have the following
	information available prior to contacting the factory:
	The model number and serial number of the generator set.
	A complete and accurate description of the part (part number if known).
	Note: Engine parts can usually be obtained from a local distributor by using the information in
	the engine manufacturer’s owner’s manual.

5-4 Troubleshooting and Maintenance MN2415