Baldor Section Receiving & Installation, 1 Generator Lifting & Mounting, AE8 & AE10, AE11

Section 3

Receiving & Installation

Receiving & Inspection When you receive your generator, there are several things you should do immediately.

1.Observe the condition of the shipping container and report any damage immediately to the commercial carrier that delivered your system.

2.Verify that the part number of the system you received is the same as the part number listed on your purchase order.

3.If the system is to be stored for several weeks before use, be sure that it is stored in a location that conforms to published storage temperature and humidity specifications.

Lifting the Generator When lift or hoist equipment is used to lift the generator and move it to position, be careful not to contact overhead wires or other obstacles. The generator can weigh as much as 1,500 lbs. Be sure lift or hoist equipment has appropriate tires for the terrain to avoid becoming stuck or tipping over. If the shipping pallet is intact, use a fork lift to move the generator. If the shipping pallet has been removed, use two steel pipes through the “Lift Point” holes to lift the generator. See Figure 3-1.

Figure 3-1 Generator Lifting & Mounting

Not To Scale		AE8 & AE10
	Four mounting		2.63
Length
	holes 0.38" dia.	8.88
			8.88
		Electrical
		Stub Up
		7.75
		Fuel Inlet on
		Horizontal Surface

Height

44.50

Lift Point

Lift Point Width

(Alternator End)

29.00

Thru Base	All dimensions are in inches.
Stub Up Area

	1.50	AE11
Stub Up		6.00
Access Panel
(Fuel & Electrical)		4.52
1.50
		42.00
		46.00
		28.00
Four mounting
holes 0.38" dia.		29.29
		(Alternator End)
LT0143A30		30.29

Six mounting			AE25
holes	0.410" dia.		30.00
	24.00
			3.19
		Fuel Inlet
		Zone
		3.19	8.12	72.00
	24.00	26.14	Electrical
			Stub Up
				20.94
			(Alternator End)
	LT0143A02		31.25

MN2415 Receiving & Installation 3-1