ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER USER’S MANUAL

D.5.4 TELEBIT NETBLAZER AND PN

If you are connecting a Router to a Telebit NetBlazer or PN (Personal Node) router, and have enabled IPX routing in both systems, you must disable PPP IPXCP compression, because the Router currently doesn’t interoperate with the NetBlazer’s IPXCP compression.

To disable PPP IPXCP compression, issue the following command to the Telebit Netblazer or PN:

ppp

options interface ipxcp compress off

and then save the configuration by entering:

save

D.6 Interoperability with CSU/DSUs

This information only applies to the Sync Router.

This section shows how to configure CSUs (channel service units) and DSUs (digital service units) for use with the Sync Router. Recommended switch settings are intended only for interoperation with the Sync Router. The CSU/DSUs are listed alphabetically.

D.6.1 BLACK BOX® CSU/DSU MS, EAZY® CSU/DSU MS, ADTRAN DSU III AR

These three CSU/DSUs provide synchronous service over DDS (digital data service), DDSII (DDS secondary channel services), or SW56 (switched-56) lines.

Connect the Sync Router to the Primary V.35 DTE connector. Use the following configuration information when using the front-panel keypad:

Local network options:

LOOP RATE: 56K, no secondary channel

NETWORK TYPE: DDS or SW56

CLOCK SOURCE:

if on a DDS, FROM NETWORK;

or

if on a point-to-point private network,

 

set one to MASTER, and the other to FROM NETWORK.

Local DTE options:

 

DTE rate:

DTE 56K/57.6K

Connector Type:

V.35

Data Format:

SYNCHRONOUS

DTE CMD:

V.25 SYNC

Transmit clock:

NORMAL

CS options:

follow RS

Anti-Stream:

timer OFF

CD options:

normal

TR options:

idle when OFF

SR options:

forced ON

116

Page 116
Image 116
Black Box LRA001A-R2 manual Interoperability with CSU/DSUs, 116, Black BOX CSU/DSU MS, Eazy CSU/DSU MS, Adtran DSU III AR