Black Box LRA001A-R2, LRS002A-R2 manual 167, Dialup iface idletime secs, Dialup iface inactive

CHAPTER

Used with synchronous ISDN TAs that do not support V.25bis dialing. We recommend you do not use these types of ISDN TAs. This command is only valid for Sync Routers.

iface	sync0
[dummy secs]	Dummy is a nonfunctioning argument. Sets the time in seconds before the Router
	hangs up on the interface iface, when there is no traffic on that interface.
dialup iface hangup

Immediately hangs up (breaks connection of) the interface iface.

dialup iface idle_time secs

Sets the time in seconds before the Router hangs up on the interface iface, when there is no traffic on that interface.

dialup iface inactive

Terminates a dialer process, leaving the line in the DTR OFF state. In this case, no incoming or outgoing calls may be made on the network. A new dialup command is required to re-activate the line. In some installations the network should be reverted to a backup line using dialup demand.

iface modem0-4, sync0

dialup iface incoming [dummy secs]

Allows only incoming calls on the line you specify. No attempt is made to dial out on this network.

iface	modem0-4, sync0
[dummy secs]	Dummy is a nonfunctioning argument. Sets the time in seconds before the Router
	hangs up on the interface iface, when there is no traffic on that interface.

dialup iface init [init_string]

Shows or sets the modem initialization string executed each time the unit or modem restarts.

iface modem0-4(the interface for which you wish to set the modem initialization string)

init_string AT modem commands.

dialup iface keepup phone# [secs]

Dials the phone number, then monitors the network and repeats the dialing process if no input was received in secs seconds even after sending echo requests to peers or in the event the modem is down.

iface	modem0-4, sync0
phone#	The phone number of the remote device you want to keep up.
secs	Monitors the network and dials again if no input was received in secs seconds even after
	sending echo requests to peers or in the event the modem is down.

dialup iface login_name name

Establishes a user name for authentication operating between dialup routers.

iface	modem0-4, sync0 (the interface for which you wish to establish a user for
	authentication)

167