Black Box LRS002A-R2, LRA005A-R2, LRA001A-R2 manual 180, Ppp i&giface ipxcp local remote default

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL

pppi&g_iface ipxcp {local remote} node [on off allow [on off]]

IPX node number—Displays or sets whether the local or remote IPX node number is announced to the other side or not. Also sets whether to allow a local or remote node number from the remote side.

ppp i&g_iface ipxcp {local remote} default

ipxcp configuration settings—Change the selected interface’s ipxcp configuration settings back to their defaults. Defaults are provided for each subcommand.

2.18.6AUTHENTICATION OF USERS

pppi&g_iface chap user username [password]

pppi&g_iface pap user username [password]

Displays or sets username to be sent when the peer requests that your Router to authenticate itself. The password to be sent may be set, but not displayed. When the username is specified, but no password is supplied, the passwd file is searched for the password. This command overrides the default name which is the system name, and the default password, which is the link password set in the config session. The username and password may be different for the CHAP and PAP authentication protocols.

username Set the username. Default is the system name.

password Set the password. Default is the link password set in the config session.

Examples

pppcommands are not required for typical use of the Router. The most common use of the ppp commands is to turn off the CHAP authentication protocol. Other commands require a more detailed knowledge of the PPP protocol and are not recommended for use without such knowledge. For example:

pppmodem0 lcp local auth none

This command sets the authentication type to none. The other choices are pap and chap.

Users often set the authentication type to none to examine the WAN link and then turn authentication back on (chap or pap) once they are satisfied that the link is functioning properly.

The following commands are often used to connect to an Ascend router’s modem. Check the parameters set on the Ascend router before using these commands. Note that the commands listed below must be issued on both sides of the connection for proper configuration:

pppmodem0 lcp local accm 0xa0000 ppp modem0 lcp local acfc off

ppp modem0 lcp local pfc off

ppp modem0 pap user user_acct pwd

180