Black Box LRA001A-R2, LRS002A-R2, LRA005A-R2 manual 194, Filter status, Ifconfig iface speed bps

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL

Enables you to relocate a filter entry name in the filter list, to a place before or after an existing filter entry existing_name. If no [before after...] clause is given, then the entry is placed last in the list. To change a filter’s priority, simply move it in the list.

filter status

Displays the list of general IPX packet filters.

Example

Add a filter to allow only SAP packets (socket 452) to pass through.

filter add fs1 -s any.any.452 -t allow

filter add fs2 -d any.any.452 -t allow -o after fs1

filter add fs3 -s any.any.any -d any.any.any -t deny -o after fs2

See also

ripfilter

sapfilter

3.7 ifconfig

Configure/display IPX network interface parameters

Syntax

ifconfig [iface [/frame_type] [network net_number] [{up down}]]

ifconfig iface [speed [bps]]

ifconfig [iface [linkaddr directory_number [/SPID]]

Description

The ifconfig command is used to assign an IPX network number to a network interface or to enable or disable IPX routing on a network interface. ifconfig is used to define the network number of each frame type on each ethernet interface present on the router. The modem interfaces are each initialized to a unique net number and do not need to be initialized; however, you can use ifconfig to change the network address of modem interfaces. Used without options, ifconfig displays the current IPX configuration of all interfaces.

NOTE

An Ethernet interface can be configured to run multiple frame types simultaneously. A unique net number must be assigned for each frame type on each interface.

Subcommands and parameters

ifconfig [iface [/frame_type] [network net_number] [{up down}]]

Assigns network characteristics to the interface specified, including frame type, network, and network

194