Black Box LRA001A-R2, LRS002A-R2, LRA005A-R2 manual 248, Ping Group, PPP Group

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL

A.2.8 PING GROUP

PING: Invalid packet size

You have entered a ping command with the packet-size parameter specified to be larger than 512K. The maximum Router ping packet size is 512K. Try the command again with a smaller packet size parameter.

PING: No known DNS servers

No domain name server is present in the current Router configuration, or no domain servers are present. If you are using Domain Name Service, use the config modify command to add one or more domain name servers to your configuration.

PING: Resolving host_name...

This message is displayed initially after entering your TCP/IP command, while the resolver is attempting to map host_name to an IP address. If the mapping is unsuccessful, the message is displayed.

PING: Unknown host: host_name

An attempt to ping host_name failed because the Router was an unable to resolve the given host_name to an IP address. Check routing to the name server and verify that Name Service is running. Try entering the IP address of the destination host rather than the host_name.

A.2.9 PPP GROUP

PPP: Unknown interface: iface

The interface specified in the ppp command could not be found. Check for typos on the command line, and re-enter the command line.

PPP: iface not a ppp interface

A ppp command was given with an incorrect interface. Enter the ifconfig command to display the available interfaces, and re-enter your command line.

A.2.10 RIP GROUP

RIP: router_addr already in RIP filter table

The rip refuse command has already been entered for router_addr.

RIP: host_address not found in the RIP table

The rip delete or rip refuse command was unable to find the specified host_address in its table.

RIP: host_address unreachable

The rip add command was unable to find a route to the given host_address.

A.2.11 SNMP GROUP

SNMP: host_addr host address already in ACL

An attempt was made to add a host to the ACL whose address was already in the ACL table.

SNMP: Community: com_name not entered

A status or set command was entered without a com_name. Re-enter the command line and include the com_name.

248