Black Box LRS002A-R2, LRA005A-R2, LRA001A-R2 manual 240, Iface line speed modemlinespeed

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL

An abnormal condition has caused the modem to hang up. The modem result code is displayed at the end of the message. Priority: LOG_ERR.

iface hangup failed

The Router attempted to hang up the phone but the modem did not respond as expected. As a result, the Router will attempt to re-initialize the modem. Wait to see if re-initialization is successful before taking any action. If not successful, reboot the Router. Priority: LOG_ERR.

iface hangup re-initialization failed

The Router has unsuccessfully attempted to re-initialize the interface. Try cycling power off then on again, to reboot the Router. This could be a modem failure. Priority: LOG_ERR

iface hangup took: xxx milliseconds

If the modem hangup took an unusually long time, this message is displayed along with the hangup time. Priority: LOG_NOTICE.

iface high usage, exceeded today’s quota of num minutes

You can set a quota limit for the amount of telephone online time allowed each day. (See Appendix B in the User’s Guide at the front of this manual.) This message means that line use has exceeded the established daily limit. You can wait until the next day when the daily quota is reinstated to make calls, or request an increase in the daily quota from your network administrator. Priority: LOG_WARNING.

iface incoming call

The Router has sensed an incoming call and has answered the phone. Priority: LOG_NOTICE

iface is busy

The modem was already busy when an attempt was made to dial up a connection. Investigate and correct the cause of the modem being already busy; then retry. If necessary, cycle the Router power off then on again. Priority: LOG_ERR.

iface line speed: modem_line_speed

Reports the actual line speed that the two modems have negotiated between themselves. The modem line speed is different than the serial port speed, as set by the ifconfig modemX speed command. Certain uncontrollable telephone conditions can cause the modem_line_speed to be lower than expected, and may also cause the modem line speed message to be absent. The modem line speed message will reappear with normal telephone line conditions. Priority: LOG_INFO.

iface link idle, hanging up

No data has been transmitted over the modem link for the specified idle timeout and the Router is dropping the telephone line, as the normal response. Priority: LOG_INFO.

iface link lost, going idle

The Router has sensed a lost carrier signal for reasons unrelated to the local modem. This usually

240