Black Box LRA005A-R2, LRS002A-R2 manual Console Messages, 244, Snmp Group, ARP Group, Dialer Group

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL

A.1.8 SNMP GROUP

SNMP Trap addr unreachable trap type type_no

An attempt was made to send an SNMP trap with type type_no to an IP destination that is unreachable. Reconfigure the SNMP access control group to specify a reachable IP address. Priority: LOG_ERR.

A.1.9 SYSTEM GROUP

Restart complete version_string

Informational message that is displayed at the completion of a startup or reboot. Priority:

LOG_NOTICE.

SYSTEM: too many entries in the passwd file (max = 10)

The Router has detected the maximum entries in the passwd file. The current maximum is 10. Delete any unused password entries, to add another. Priority: LOG_WARNING.

A.2 Console Messages

This section contains a listing of error and information messages, that are displayed either on the serial port console attached to the Router, or on a remote console (in use during a Telnet session with the Router).

If no local or remote console is in use, these messages will not appear.

Certain messages are prefixed with a capitalized name and a colon. This prefix is the name of the Router software module that originated the message. When calling Technical Support about a message, mention this module’s name. The prefix names are listed in alphabetical order with their associated messages.

A.2.1 ARP GROUP

ARP: iface Attach device first

While processing an arp command, the Router has determined that the Ethernet interface is not working, or is not configured. Run the ifconfig command to determine the state of the Ethernet interface. Re-issue the ifconfig command to mark the interface up, if necessary.

ARP: Unknown host: host_name

An attempt to enter a host name failed because the Router was unable to resolve the host_name to an IP address. Check for typos on your command line.

A.2.2 DIALER GROUP

DIALER: dialup once: iface already connected

A dialup once command was executed to dial on the modem. However, the dialer detected that the modem was already connected. Use dialup reset to send a hangup command to the modem; then try again.

DIALER: dialup once: iface is busy

The dialup once command can be used to verify a dialer script file or to verify a valid telephone line. This message normally means that the phone on the other end is busy. Try again later or investigate the reason for a busy phone. Use the dialup reset command if the modem at the other end of the phone line

244