Black Box LRA001A-R2, LRS002A-R2, LRA005A-R2 manual 239, Iface dialer script failed failuremessage

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL

iface canned dialer failed: reason

The Router failed to establish a modem link at the destination, using the factory-configured (canned) dialup commands; the reason for failure is displayed: NO CARRIER, BUSY, NO DIALTONE, NO ANSWER. Priority: LOG_ERR.

iface can’t dial: exceeded today’s quota of xxx minutes

The dialup command includes an option to set time quotas to limit the expense during set time periods, for the cost of long distance telephone lines. Wait until the next day to establish a modem connection (when the daily quota is reinstated), or explore the option with your network administrator for extending the quota limit. Priority: LOG_ERR.

iface can’t dial: DCD is high

An attempt to dial out found Data Carrier Detect (DCD) signal already on. DCD must be off to dial out. Check the telephone line to determine if the remote end is off hook. Check the modem initialization string with the config show command to verify that the &C1 command is included, and use the dialup status command to monitor the status of DCD. Priority: LOG_ERR.

iface can’t read dialer script file_name.

The Router was unable to find the specified dialer script, file_name. Be sure the file_name specified in the dialup command is not misspelled, and verify that the file is on the boot disk. Priority: LOG_ERR.

iface current speed(bps): num

A syntax error was detected while attempting to set the modem speed. This error will cause any dialer script to terminate prematurely and leave the modem speed unchanged. Correct the syntax error in your dialup script file and run the script again. Priority: LOG_ERR.

iface dialer script failed failure_message

The dialer script has failed. Since the script file was most likely validated during its setup, check to see if any of the destination parameters have changed. Continue debugging the dialer script until it is again validated for use. Priority: LOG_ERR.

iface Dialing for destination_addr

An informational message that appears when dialing is initiated for a remote connection. This message can help you determine what type of traffic is causing the Router to dial. Priority: LOG_DEBUG.

iface dialup link appears to be up

The Router has dialed a phone number and has established a connection over the interface. Priority: LOG_INFO.

iface dropping link, exceeded today’s quota of num minutes

The dialup command includes an option to set daily time quotas, to limit the expense for the cost of long distance telephone lines. Wait until the next day to establish a modem connection, or explore the option with your network administrator for extending the daily quota limit. Priority: LOG_WARNING.

iface hanging up, status returned: modem_result_code

239