Black Box LRS002A-R2, LRA005A-R2, LRA001A-R2 manual 249, System Group

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL

SNMP: bad host address, host_addr

The Router was unable to resolve the host_addr given in the snmp set command. Verify that host_addr is correct; the name server or host data base has host_addr; and re-enter the command line.

SNMP: maximum host addresses exceeded, cant add: host_addr

An attempt was made to add another host_addr when the maximum of eight addresses per community are already in the Access Control List (ACL). Delete an unused host_addr.

SNMP: community_name not added, maximum community names exceeded

An attempt was made to add another community_name when the maximum of eight community definitions are already in the Access Control List. Delete any unused communities to make room.

SNMP: host_addr host address not in ACL

An attempt to delete host_addr from the Access Control List (ACL) failed. Use the snmp status -c community_name command to display contents of the ACL. Check for typos, verify that host_addr is valid, and re-enter the command line.

SNMP: Access control list is empty

A command line was issued that initiated display of community information and the Access Control List was found to be empty.

SNMP: No communities configured

A command line was issued that initiated display of SNMP communities, and it was found that no communities were configured.

A.2.12 SYSTEM GROUP

SYSTEM: Make sure the floppy disk is write enabled

Verify that the boot disk is write-enabled and fully inserted in the Router’s disk drive. Re-enter the command line.

SYSTEM: Mismatch - password unchanged

During the process of changing the existing password and after the prompt to re-enter the new password, a mismatch was found between the two entries. Try again.

SYSTEM: Please use at least one non-numeric character

A valid Router password requires at least one non-numeric character. Try again.

SYSTEM: Please use a longer passwd

A valid Router password requires at least eight characters. Try again.

SYSTEM: Cannot create config temp file: file_name

The Router was unable to open and read file_name. Verify that a valid boot disk is inserted in the Router’s disk drive and verify that file_name is on the boot disk. Re-enter the command line.

SYSTEM: Unknown interface: iface_name

An incorrect interface name was specified on your command line. Issue the ifconfig command to obtain a list of currently valid interfaces for your Router. Re-enter your command line.

249