Toshiba e-STUDIO500P Ready-Binx Full displays and paper feeds into bin, Xx Service Error displays

Ready—Binx Full displays and paper feeds into bin x

	FRU	Action
1	Bin x sensor	Check the sensor flag for binds. Make sure the sensor flag is not in
	Bin x sensor control board	an up position. If the sensor flag is operating correctly, replace the bin
		x sensor. If this does not fix the problem, replace the control board.

271.xx Paper Jam - Check Bin 1 displays—paper does not feed into the bin selected

	FRU	Action
1	Deflector	Check all the bin parts for missing or loose springs, binds in the
	Deflector spring	deflector or deflector cover, broken or binding shaft assemblies, or
		broken gear teeth. If incorrect, repair as necessary.
	Deflector cover
	Deflector cover spring
	Shaft assemblies
2	Bin x solenoid assembly	Check the solenoid for any binds. Make sure the solenoid is
	Control board	contacting the latch correctly. If incorrect, repair as necessary. If the
		solenoid appears to be operating mechanically, check the resistance
		of the solenoid. It measures between 30 and 50 ohms. If incorrect,
		replace the failing solenoid assembly. If correct, replace the control
		board.
3	Mechanical linkage	If the DC motor is functioning properly, check the gears, clutch, and
	Motor assembly	other linkage parts for correct operation and wear, broken gear teeth,
		or damaged parts. If incorrect, replace the mechanical linkage
		assembly/DC motor assembly.
990.xx Service Error displays

		FRU	Action
	1	Mechanical linkage	Check the DC motor cable connector to be sure it is correctly
		DC motor assembly	installed at J2 on the control board. If correct, disconnect J2 from the
			control board and check the resistance of the motor on the cable
			connector. J2-1 to J2-2 measures between 115 and 135 ohms. Also
			check J2-1 and J2-4 to the motor case for shorts. If either the
			resistance is incorrect or a short is found, replace the mechanical
			linkage/DC motor assembly.
			Note: If the DC motor is shorted, it may also be necessary to replace
			the control board.
	2	Control board	Disconnect the motor cable J2 from the control board and check the
			voltages at J2 on the board.
			Warning: Use caution not to short adjacent pins on the connector as
			damage to the board could result.
				Pin	Measured (motor idle)
				J2-1	+24 V dc
				J2-2	+24 V dc
				J2-5	+5 V dc
				J2-6	+5 V dc
			If any of the voltages are incorrect, replace the control board. If
			correct, replace the mechanical linkage/ DC motor assembly.
2-74Service Manual