Toshiba e-STUDIO500P manual Actions may be taken

User attendance messages (continued)

Error	Sub	Primary message	Description/action
code	code
37	.xx	Insufficient Memory	This message displays when the printer memory used to restore the Print
			and Hold jobs from the disk and found that some or all of the jobs could not
			be restored. The printer ran out of memory while attempting to restore the
			jobs.
			•	Press		to clear the message. Some of the Print and Hold jobs on the
				disk will not be restored. They remain on the disk, but cannot be
				accessed.
			•	Press		until Busy/Waiting appears. The following functions may be
				available:
				-	Cancel Job
				-	Reset Printer
				-	Reset Active Bin
38	.xx	Memory Full	This message displays when the printer is processing an incoming job and
			there is insufficient memory available to continue processing the job. The
			following actions may be taken:
			•	Press		to clear the message. Perform the defragment operation:
				-	Perform the defragment operation
				- Delete fonts, macros, and other data in RAM
				-	Install additional memory
			•	Press		to display Busy/Waiting. The following functions may be
				available:
				-	Cancel Job
				-	Reset Printer
				-	Reset Active Bin
39	.xx	Complex Page	This message displays when the page is too complex to print. The following
			actions may be taken:
			•	Press		to clear the message and continue the job. Some data loss
				may occur. Simplify the print job and reprint, if necessary.
			•	Press		until Busy/Waiting appears. The following selections are
				possible:
				-	Cancel Job
				-	Reset Printer
				-	Reset Active Bin
50	.xx	PPDS Font Error	This message displays when the PPDS interpreter has encountered a font
			error.
			Note: This error may only occur when the printer is formatting PPDS print
			data.
			The following actions may be taken:
			•	Press		to clear the message and continue processing the job.
			•	Press		until Busy/Waiting appears. The following are available:
				-	Cancel Job
				-	Reset Printer
				-	Reset Active Bin
51	.xx	Defective Flash	This message displays when the printer detects a defective flash. This error
			may occur at power on, or during flash format and write operations. Press
				to clear the message. The flash is marked as bad and normal operation
			continues. Flash operations are not allowed until the problem is resolved.

Diagnostic information 2-39