Toshiba e-STUDIO500P manual Paper activate springs and ITC switches

Tray 1 not recognized as being installed; unable to clear Tray 1 Missing message

	FRU	Action
1	Tray 1	Check Tray 1 for damaged or broken autosize fingers. Check for
		anything that would prevent the autosize fingers from activating the
		paper activate springs and ITC switches.
		LGL
		A4
		LTR
		EXEC
		B5
		A5
		2
		W
		S
		1
		W
		S
		0
		W
		S

		If a problem is found, repair or replace the tray assembly. If no
		problem is found, go to step 2.
2	Integrated card/	Check for correct installation of the cable at J26 on the system board.
	autocompensator cable	If installed correctly, go to step 3. If incorrectly installed, install and
		recheck the printer.
3	System board	Check the continuity between J26-2 on the system board and
		ground. It should measure approximately 0 ohms.

2-114Service Manual