950.00 through 950.29 EPROM mismatch failure

Warning: When replacing any one of the following components:

Operator panel assembly (or upper front cover)

System board assembly

Interconnect card assembly

Only replace one component at a time. Replace the required component and perform a POR before replacing a second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the components listed above without a POR after installing each one or the printer will be rendered inoperable.

Warning: Never install and remove components listed above as a method of troubleshooting components. Once a component has been installed in a printer, it can not be used in another printer. It must be returned to the manufacturer.

This error code indicates a mismatch between the operator panel board and the interconnect card.

 

FRU

Action

 

 

 

1

Interconnect card

If the interconnect card been recently replaced, go to step 3. If the

 

 

card has not been replaced go to step 2.

 

 

 

2

operator panel board

If the operator panel board has been recently replaced, go to step 4.

 

 

If the operator panel board has not been replaced, contact your next

 

 

level of support.

 

 

 

3

Interconnect card

Replace the current interconnect card assembly with the original

 

 

interconnect card assembly. See “Interconnect card assembly

 

 

removal” on page 4-53.

 

 

If the error remains, go to step 5.

 

 

 

4

operator panel board

Replace the current operator panel board with the original operator

 

 

panel board. See “Operator panel board removal” on page 4-66.

 

 

If the error persists, go to step 6.

 

 

 

5

Interconnect card

Replace the original interconnect card assembly with a new and not

 

 

previously installed interconnect card assembly. If the error remains,

 

 

contact your next level of support.

 

 

 

6

Operator panel

Replace the original operator panel board with a new and not

 

 

previously installed interconnect card assembly. If the error remains,

 

 

contact your next level of support.

 

 

 

Diagnostic information 2-77

Page 113
Image 113
Toshiba e-STUDIO500P manual Through 950.29 Eprom mismatch failure, Panel board. See Operator panel board removal on