Toshiba e-STUDIO500P manual User line 2 link messages, Check device connection messages

User line 2 link messages

If the printer is locked on a particular link, the link indication displays. If the printer is ready to process any link, no messages display. Link messages are listed in the following table.

User message	Explanation
Parallel	Standard Parallel Port, if available.
Serial	Standard Serial Port, if available.
Serial x	Serial Port is attached to PCI connector x, where x=1, 2, or 3.
Network x	Network card x is attached to PCI connector x, where x=1, 2, or 3.
LocalTalk x	LocalTalk Card x is attached to PCI connector x, where x=1, 2, or 3.
Infrared	Standard Infrared port, if available.
Infrared x	Infrared Port x is attached to PCI connector x, x=1, 2, or 3.

Check device connection messages

The messages in the following table display when the printer loses communications with one of the following devices.

User status message	Explanation
Check Env Feeder	Check envelope feeder connection.
Connection
Check Tray x Connection	Check tray x, where x=1, 2, 3, 4, or 5.
Check Duplex	Check duplex option connection.
Connection

The messages in the following table can occur in two ways. The specified device could have been removed from the printer, for instance to clear a paper jam. Otherwise, the device can still be attached to the printer, but is experiencing a communications problem, not fully connected, or having a hardware failure.

If the device is temporarily removed or not connected properly, then the user is advised to reattach it. When the option is recognized, the printer automatically clears the error and continues. If the option is experiencing a hardware problem, turn the printer off and back on. If the error occurs again, the user is advised to turn the printer off, remove the option, and call for service.

User status message	Explanation
Turn Printer OFF to	A printer option, Input Tray, or Envelope Feeder has been attached while the printer
Enable Option	is powered on. To use the option, the printer must first be powered off and back on
	again. Data loss results if print jobs are active when the printer is power cycled. If a
	print job is active, then remove the option and finish the job. The printer
	automatically clears the message once the option is removed. Once the job is
	complete, turn off the printer and attach the option again.
Insert Duplex Front	The duplex front access cover is not installed.
Cover
Close Duplex Rear Door	The duplex rear door is open.

Diagnostic information 2-43