Toshiba e-STUDIO500P manual Xx Paper Jam displays, envelope stops in feeder paper path

260.xx Paper Jam displays, envelope stops in feeder paper path

	FRU	Action
1	Kick rolls/feed rolls/drive	Check all the rolls for oil, grease, or other contamination. If you find a
	rolls	problem, clean the rolls. If this does not correct the problem, replace
		the envelope feeder.
2	Deflector gap adjustment	Check the deflector gap adjustment. The adjustment may be too
		narrow. If the adjustment is correct, replace the envelope feeder
		option.
Envelope feeder multifeeds or may not display a 260.xx Paper Jam message

	FRU	Action
1	Envelopes	Check the envelopes being used in the feeder. Check for signs of the
		envelopes being stuck together or signs of glue. Make sure the flaps
		are not interleaved.
		If the envelopes meet the guidelines and are properly loaded, go to
		step 2.
2	Deflector	Check the deflector gap adjustment. The adjustment may be too
		wide.
		If the deflector gap adjustment is correct, go to step 3. If not, replace
		the envelope feeder option.
3	Restraint roll bias spring	Check for a missing, broken or incorrectly installed restraint roll bias
		spring. If incorrect, replace the envelope feeder option.

260.xx Paper Jam displays, an envelope stopped in the paper path of the feeder and an envelope also stopped in the base printer paper path

	FRU	Action
1	Latch lever	Make sure the tip of the latch lever is centered in the opening in the
		floor of the paper path. The latch lever may not be detented on the
		latch. If no problem is found and the problem persists, replace the
		envelope feeder option.

2-86Service Manual