Toshiba e-STUDIO500P manual Assembly removal on

User attendance messages—paper jams and paper handling errors (2xx.xx)

Error	Sub	Description	Possible causes	Action
code	codes
202	.52	Exit sensor covered too	Page may be jammed in fuser exit or	• Make sure the redrive door
		long. Fuser page count	redrive area.		is complete closed.
		stopped at 500,000 to		•	Check the fuser for any
		preserve data.
					signs of wear or
					contamination. If any are
					found, replace the fuser
					assembly. See “Fuser
					assembly removal” on
					page 4-26.
				•	Turn media over to reduce
					+W curl.
				•	Check upper redrive
					diverter and diverter spring
					for any signs of damage, a
					loose spring, or binding
					parts. Repair the redrive as
					necessary.
				•	Check any installed output
					options(s) that may be
					installed for correct
					installation and alignment.
				•	The fuser exit sensor may
					not be functioning properly.
					Go to “Fuser exit sensor
					service check” on
					page 2-92.
202	.53	Page is covering narrow	• If page is not visible from front or rear	Check the fuser and area
		media sensor during	of the printer, a partial piece of a	around the fuser assembly for
		warm up. Fuser page	page may be torn off in the fuser	any signs of debris or pieces of
		count stopped at	covering the narrow media sensor.	paper or media.
		500,000 to preserve	• The narrow media sensor or flag may
		data.
			be dislodged or damaged.
202	.54	Exit sensor may have	Exit sensor assembly.	Go to “Fuser exit sensor
		bounced. Fuser page		service check” on page 2-92.
		count stopped at
		500,000 to preserve
		data.
202	.56	Page is covering the exit	Something is keeping the exit sensor in a	Check the fuser and area
		sensor during warm	covered position. A page may not have	around the fuser assembly for
		up.Fuser page count	been cleared from a prior jam.	any signs of debris or pieces of
		stopped at 500,000 to		paper or media.
		preserve data.

2-64Service Manual