Toshiba e-STUDIO500P manual Or reconnect it

User attendance messages (continued)

Error	Sub	Primary message	Description/action
code	code
		Reattach	Bins x–y=Bins 1 to 5, Bins 2 to 6, or Bins 6 to 10
		Bins x–y	This messages displays for the following conditions:
			•	The specified output bins may have been removed from the printer,
				possibly to clear a paper jam or to remove the option.
			•	The option(s) may be attached to the printer but a communications
				problem may prevent the printer from detecting the option. For example,
				there may be a poor connection or a hardware failure.

The following actions may be taken:

•If the option was temporarily removed or not connected properly, reattach or reconnect it.

•Press to execute a configuration change which notifies the printer the option has been hot unplugged (removed with the power on).

Note: This action is not available if the printer is in Diagnostics Mode or running diagnostics.

•If the device is experiencing a hardware problem, turn the printer off and on. If the message continues to be displayed, go to “Input tray(s) service check” on page 2-102.

Reattach	This messages displays for the following conditions:
Envelope Feeder	•	The feeder may have been removed from the printer, possibly to clear a
		paper jam or to remove the option.
	•	The feeder may be attached to the printer but a communications problem
		may prevent the printer from detecting the option. For example, there
		may be a poor connection or a hardware failure.
	The following actions may be taken:
	• If the option was temporarily removed or not connected properly, reattach
		or reconnect it.
	•	Press	to execute a configuration change which notifies the printer the
		option has been hot unplugged (removed with the power on).
		Note: This action is not available if the printer is in Diagnostics Mode or
		running diagnostics.
	•	If the device is experiencing a hardware problem, turn the printer off and
		on. If the message continues to be displayed, go to “Envelope feeder
		service check” on page 2-84.
Reattach	Bin x=Bin 1, Bin 2, or Bin 3
Output Bin x	This messages displays for the following conditions:
	•	The specified output bin may have been removed from the printer,
		possibly to clear a paper jam or to remove the option.
	•	The option may be attached to the printer but a communications problem
		may prevent the printer from detecting the option. For example, there
		may be a poor connection or a hardware failure.
	The following actions may be taken:
	• If the option was temporarily removed or not connected properly, reattach
		or reconnect it.
	•	Press	to execute a configuration change which notifies the printer the
		option has been hot unplugged (removed with the power on).
		Note: This action is not available if the printer is in Diagnostics Mode or
		running diagnostics.
	•	If the device is experiencing a hardware problem, turn the printer off and
		on. If the message continues to be displayed, go to“Output expander
		service check” on page 2-110.

Diagnostic information 2-37