Toshiba e-STUDIO500P manual Formatted Scheduled Maintenance, Go to Scheduled maintenance on

User attendance messages (continued)

Error	Sub	Primary message	Description/action
code	code
59	.xx	Incompatible Tray x	An incompatible tray is installed. For Tray x, x= 2, 3, 4, or 5.
			Remove the incompatible tray and press				to clear the message.
			Note: If the user installed the incompatible device to satisfy a Check Device
			Connections/reattach message, the user should reinstall an associated
			compatible option or hot unplug the option.
59	.xx	Incompatible Duplex	An incompatible duplex option is installed.
			Remove the incompatible duplex option and press					to clear the message.
			Note: If the user installed the incompatible device to satisfy a Check Device
			Connections/reattach message, the user should reinstall an associated
			compatible option or hot unplug the option.
59	.xx	Defective Disk	This error code displays when the printer detects a defective disk. This error
			may occur at power on or during disk format and write operations. While this
			message displays, press			to clear the message. The disk is marked
			defective and normal printer operations continue. Disk operations are not
			allowed with a defective disk. The Format Disk menu is not shown.
62	.xx	Disk Full	This error code displays when there is not enough free space on the disk to
			hold the resources that have been requested to be written to the disk. This
			message displays for both resource and PostScript Disk operators when the
			disk is full.
63	.xx	Unformatted Disk	This error code displays when the printer detects an unformatted disk at
			power on. Press		to clear the message. The disk is marked as bad and
			normal operation continues. Disk operations are not allowed until the disk is
			formatted.
64	.xx	Unsupported Disk	The printer detects an unsupported disk format at POR.
		Format	Press	to clear the message. The disk is marked as bad and normal
			operation continues. Further disk operations are not allowed until the disk is
			formatted.
80	.xx	Scheduled Maintenance	The operator panel displays this message at each 300K page count interval.
			It is necessary to replace the fuser assembly, transfer roller, charge roll, and
			pick rolls at this interval to maintain the print quality and reliability of the
			printer. The parts are available as a maintenance kit. For more information,
			go to “Scheduled maintenance” on page 6-1.
81	.xx	Engine Code CRC	This error displays when the microcode to be programmed in the engine
		Failure	flash code module has failed a CRC check. Press					to clear the message.
			The microcode data is discarded and must be re-transmitted from the host
			computer.
.88	.xx	Toner Low	This message displays when toner low occurs and the toner low alarm is
			activated. Press		to clear this message.
1565	.xx	Emul Error	This message appears when the IPDS emulation version contained in the
		Load Emul Option	SIMM does not function with the printer code. This message automatically
			clears in 30 seconds, and the IPDS emulation is disabled. No other printer
			functions are affected. The correct IPDS emulation must be downloaded.

2-42Service Manual