Toshiba e-STUDIO500P manual Bounced. Fuser

User attendance messages—paper jams and paper handling errors (2xx.xx)

Error	Sub	Description	Possible causes	Action
code	codes
202	.22	Exit sensor covered too	Page may be jammed in fuser exit or	• Make sure the redrive door
		long. Fuser page count	redrive area.		is complete closed.
		between 200,000 and		•	Check the fuser for any
		299,999.
					signs of wear or
					contamination. If any are
					found, replace the fuser
					assembly. See “Fuser
					assembly removal” on
					page 4-26.
				•	Turn media over to reduce
					+W curl.
				•	Check upper redrive
					diverter and diverter spring
					for any signs of damage, a
					loose spring, or binding
					parts. Repair the redrive as
					necessary.
				•	Check any installed output
					options(s) that may be
					installed for correct
					installation and alignment.
				•	The fuser exit sensor may
					not be functioning properly.
					Go to “Fuser exit sensor
					service check” on
					page 2-92.
202	.23	Page is covering narrow	• If page is not visible from front or rear	Check the fuser and area
		media sensor during	of the printer, a partial piece of page	around the fuser assembly for
		warm up. Fuser page	may be torn off in the fuser covering	any signs of debris or pieces of
		count between 200,000	the narrow media sensor.	paper or media.
		and 299,999.	• The narrow media sensor or flag may
			be dislodged or damaged.
202	.24	Exit sensor may have	Exit sensor assembly	Go to “Fuser exit sensor
		bounced. Fuser page		service check” on page 2-92.
		count between 200,000
		and 299,999.
202	.26	Page is covering the exit	Something is keeping the exit sensor	Check the fuser and area
		sensor during warm up.	covered. A page may not have been	around the fuser assembly for
		Fuser page count	cleared from a prior jam.	any signs of debris or pieces of
		between 200,000 and		paper or media.
		299,999.

2-58Service Manual