Toshiba e-STUDIO500P manual Fuser narrow media sensor service check

Fuser narrow media sensor service check

If any of the following error codes are displayed, a problem may exist in the area of the narrow media sensor assembly: 201.04, 201.14, 201.24, 201.34, 201.44, 201.54, and 201.94.

Fuser exit and fuser narrow media sensor status check

Printer not printing— no media		Printer printing—media over		Printer printing—narrow media
		sensor(s), non-narrow media fed
over sensors				fed through the printer
		through the printer
Exit sensor open		Exit sensor closed		Exit sensor closed
Narrow media sensor open		Narrow media sensor closed		Narrow media sensor open
	FRU		Action
1	Fuser narrow media sensor		Enter the Diagnostics mode, select BASE SENSOR TEST, and
	(sensor test)		select the NM Sensor to test it for proper operation. If the narrow
			media sensor fails the test, go to step 2; if the narrow media sensor
			does not pass the test, go to step 5.
2	Fuser narrow media sensor		Check the fuser narrow media sensor cable for correct installation or
	cable		any signs of damage to the cable or to the connectors. If no problem
			is found, go to step 3;. If a problem with the installation is found,
			install the cable correctly. If damage to the cable or the connectors is
			found, replace the cable.
3	Fuser narrow media sensor		Make sure the sensor flag is not binding and is operating properly. If
	flag		the sensor is operating properly, go to step 4. If the sensor is not
			operation properly, repair or replace the sensor assembly. See
			“Fuser narrow media sensor removal” on page 4-34.
4	Fuser assembly		Check the continuity of the fuser narrow media sensor cable. If
	Fuser narrow media sensor		incorrect, replace the cable; if correct, check the continuity of the
			fuser to system board cable. If incorrect, replace the cable; if correct,
	cable
			replace the following FRUs in the order shown:
	Fuser board
			• Fuser board
	Fuser to system board
			• Fuser assembly. See “Fuser assembly removal” on page 4-26.
	cable
			• System board. See “System board and inner shield removal”
	System board
			on page 4-76.
5			With the redrive assembly removed from the printer, enter
			Diagnostics mode and run the printer test from tray 1 and observe
			the media as it passes over the exit sensor. Check to see that the
			sensor flag is operating correctly. If the sensor flag and hardware are
			operating incorrectly, repair or replace the failing sensor assembly. If
			no problem is found, check the fuser for any signs of media in the
			fuser or any signs of toner or other contamination. If a problem is
			found, clean or remove the debris or contamination.

Diagnostic information 2-93